Measuring beam for ATORN round table tester

Application

Makes it easier to position the articulated arm tripod in relation to the component to be checked. The knurled fixing screw (included in the scope of supply) is used to fix the articulated arm tripod to the measuring bar by means of a sliding block. The measuring bridge is screwed directly to the round test table housing using two screws (included in the scope of supply).

Execution

• measuring bar DNC coated
• T-groove 18mm over the entire length
• two front drill holes
• knurled fixing screw M12/ M8
• ATORN 3D articulated arm tripod with 330 mm operating radius
• ATORN fine adjustment for holding e.g. dial gauge or lever gauge probe, etc.
• T-shaped sliding block 18mm with M12 thread

Notes

Measuring bridge for holding two 3D articulated arm tripods (article number 35490340) available as an option.